The minimum sheet width is 7" and the maximum sheet length is 22". If the sheet is length is over 17-1/2", then it must be at least 8-1/2" wide.

Grain direction must be with the folds. Grain wrong setup of $70.00 and an additional 5% may be added to the run charge.

The caliper of the stock must be between .0045 and .0068. 10% is added to the Run Charge for matte or gloss coated stock.

An over run for setup and waste is required. The minimum is 300 or 10%, whichever is greater of the finished count.

Because of critical panel sizes needed for accurate folding, it is recommended that ECS trim your stock to the one-up sheet. Critical folding register of pre-trimmed stock cannot be guaranteed. $70.00 per hour cutting charge will apply.

We can fold 3, 4, or 5 panels into a glued pocket with 1 or 2 perfs and a remoisten gum strip all parallel with the folds. Check if your piece will be roll folded or double parallel folded.

To find the correct price group, you will need to count the panels your piece has. Remember to count the glued pocket as panel 1 and 2.